InfoCoBuild

Design Practice II

Design Practice II. Instructor: Dr. Shantanu Bhattacharya, Department of Mechanical Engineering, IIT Kanpur. The course is intended for beginners in post graduate studies in Design. It can also serve well for aspiring professionals in industry who will be willing to undertake careers in the field of design. Topics covered in this course include Computer Aided Design, Geometric modeling, Representation of curves, Representation of surfaces, MEMS, Computer numerical control, CNC tooling, Rapid prototyping, and Mechatronics. (from nptel.ac.in)

Lecture 10 - Representation of Surfaces

This lecture module covers the following topics: parametric equation, representation of Surface, etc.

Go to the Course Home or watch other lectures:

Lecture 01 - Design Concepts

Lecture 02 - Computer Aided Design (CAD)

Lecture 03 - Geometrical Transformation

Lecture 04 - Composition of Geometrical Transformation

Lecture 05 - Geometric Modeling

Lecture 06 - Representation of Curves

Lecture 07 - Parametric Representation of Synthetic Curves

Lecture 08 - Curve Fitting Problem (Hermite Case)

Lecture 09 - Problem Solving (based on Bezier Curve)

Lecture 10 - Representation of Surfaces

Lecture 11 - Introduction to Microelectromechanical Systems (MEMS)

Lecture 12 - Lab-on-Chip

Lecture 13 - Introduction to Sensors

Lecture 14 - Introduction to Transducers

Lecture 15 - Device Fabrications

Lecture 16 - Introduction to Silicon as a MEMS Material

Lecture 17 - Etching Processes

Lecture 18 - Types of Photolithography

Lecture 19 - Introduction to Actuators

Lecture 20 - Designing of the Microvalve

Lecture 21 - Electrochemical Valves

Lecture 22 - Micropumps

Lecture 23 - Designing of Peristaltic Pumps

Lecture 24 - Different Types of Pumps and Sensors

Lecture 25 - Sensors and Actuators Design

Lecture 26 - Computer Numerical Control

Lecture 27 - Numerical Control Programming

Lecture 28 - NC Part Programming

Lecture 29 - CNC Tooling, Rapid Tooling, Rapid Prototyping

Lecture 30 - Introduction to Rapid Prototyping

Lecture 31 - Different Types of Rapid Prototyping Technologies

Lecture 32 - Fused Deposition Modeling

Lecture 33 - Lab Demonstration of Fused Deposition Modeling Techniques

Lecture 34 - Lab Demonstration of Fused Deposition Modeling Techniques (cont.)

Lecture 35 - More on CNC Tooling, Rapid Tooling and Rapid Prototyping

Lecture 36 - Introduction to Mechatronics

Lecture 37 - Thermal Cycling for PCR

Lecture 38 - Mechatronics (cont.)