InfoCoBuild

Circuits for Analog System Design

Circuits for Analog System Design. Instructor: Prof. M. K. Gunasekaran, Department of Electronics Design and Technology, IISc Bangalore. This course will concentrate on three aspects: 1) how to design and analog circuits, 2) error budgeting, and 3) various techniques involved in analog circuits. Topics covered in this course include an introduction to linear IC applications, design and error budget analysis of signal conditioners for low level ac and dc applications, signal conditioners with instrumentation autozero/chopper/isolation/charge amplifiers, design and applications of active filters and high frequency circuits, design of multi channel low level and high level data acquisition systems using ADC/DAC, SHA and analog multiplexers, and designing of low power circuits for transducers. (from nptel.ac.in)

Lecture 01 - Transistor Amplifier

Go to the Course Home or watch other lectures:

Transistor Applications

Lecture 01 - Transistor Amplifier

Lecture 02 - Transistor Op-Amp and Transistor based Voltage Regulator

Lecture 03 - Some Applications of Transistor, Part I

Lecture 04 - Some Applications of Transistor, Part II

Transformer and Heat Sink Design

Lecture 05 - Transformer Design and Heat Sink Design

Op-Amp Applications

Lecture 06 - Op-Amp based Linear Voltage Regulator

Lecture 07 - Short Circuit Protection for Linear Power Supply

Lecture 08 - Temperature Indicator Design using Op-Amp

Lecture 09 - On and Off Temperature Controller Design

Lecture 10 - Proportional Temperature Controller Design

Lecture 11 - PID - Temperature Controller Design

Lecture 12 - Heater Drive for Various Temperature Controllers

Lecture 13 - Short Circuit Protection of Power MOSFET

Error Budgeting

Lecture 14 - Error Budgeting for Temperature Indicator

Lecture 15 - PID Temperature Controllers with Error Budgeting

Lecture 16 - Error Budgeting for Constant Current Sources

Lecture 17 - Error Budgeting for Thermo Couple Amplifier

Lecture 18 - Error Budgeting for Op-Amp Circuits

Lecture 19 - Gain Error Calculation in Op-Amp Circuits

Lecture 20 - Input Resistance Calculations for Op-Amp

Lecture 21 - Output Resistance Calculations for Op-Amp

Lecture 22 - Error Budgeting for Different Circuits

4-20mA Current Transmitter

Lecture 23 - 4-20mA Current Transmitter Design

Lecture 24 - Error Budgeting for 4-20mA Current Transmitters

Lecture 25 - LVDT based Current Transmitters

Lecture 26 - Constant Current Source Design

Lecture 27 - 4-20mA based Temperature Transmitter

Lecture 28 - 3-Wire Current Transmitter

Resistance and Capacitance Measurement

Lecture 29 - Various Resistance Measurement Techniques

Lecture 30 - Ratio Transformer Technique to Measure Resistance and Capacitance

Lecture 31 - Capacitive Sensor Circuit Design Examples

Lecture 32 - Capacitive Sensor Circuit with High Impedance Amplifier

AC Applications of Op-Amp

Lecture 33 - AC Applications of the Op-Amp and Lock in Amplifier Design

Lecture 34 - Design of Lock in Amplifier Circuit with Example

ADC/ DAC

Lecture 35 - Dual Slope ADC - Design Examples

Lecture 36 - Dual Slope ADC and Successive Approximation ADC

Lecture 37 - MC based ADC

Lecture 38 - Digital to Analog Converter Design and Working, Flash ADC

Lecture 39 - Flash ADC and ADC Converter Errors

Lecture 40 - Sigma Delta ADC Working Principle